It is mainly used to meet the burn-in requirements of 5G communication energy low-voltage three-phase 4KW and single-phase 6KW products, and is compatible with the burn-in test of 2KW and energy board power products to meet the factory test requirements. A single set of burn-in test system includes burn-in cabinet product cabinet (including temperature)control, power distribution, monitoring, etc.), burn-in distribution cabinet, load system, etc.

Performance parameters

Project	Specification requirements
Burn-in test capacity	1200W/CH,60CH
Rated insulation voltage	690VAC
Rated frequency	50Hz
Operating temperature	Room temperature + 10℃ ~ 60℃ ± 5℃
Output channel specifications	380VAC/Three-phase 60A
Monitoring rate	The refresh interval of digitally collected information in the cabinet needs to be less than 1s
Smoke sensor type	Overhead installation type smoke sense, normally closed point work
Temperature rise of power distribution components	Complies with the provisions of IEC 60947-1 on temperature rise, and the temperature rise value does not exceed the corresponding standard requirements of the component
Leakage Protection	The power input of the cabinet must match the power leakage protection function of the equipment. The AC side needs to be installed with a 30mA leakage protection circuit

Inquiry Cart 0

5g Base Station Outdoor Communication Power Supply Aging Test Equipment

Power Supply Burn In Chamber

LED Driver Burn In Chamber

SMPS Power Supply Burn In Chamber

EV Charger Burn In Chamber

Charger and Adapter Aging Rack Machine

Power Bank Aging Test Equipment

TV Power Supply Aging Test Chamber

Inverter Aging Test Equipment

Energy Storage Power Aging Test Equipment

Vehicle Central Control Display Aging Test Equipment

New Energy Solutions

Automated Burn In Test Solutions

ATE Solution

Electronic Load Solutions

5g Base Station Outdoor Communication Power Supply Aging Test Equipment