Shenzhen CPET Electronics Co., Ltd.
Add to Cart
Travel Multi-Port Seat Mobile Phone Charger Plug Micro-USB Burn-In Test Equipment
Application Scope
Power sources such as chargers, power adapters, electric bicycle battery charger,wireless charging, power tool charger,sweeper charger,etc.
| 1 | Introduction to the appearance and structure of the power aging trolley: | |
| A | Car size (mm) : | L2050*W880*H1900 |
| B | Number of car layers: | 6 |
| C | Height of truck: | 170mm |
| D | Car structure material | Thick, cold rolled sheet |
| E | Load area heat dissipation mode: | Top turbine exhaust fan up-row (easy ring temperature control) |
| F | Interlayer insulation and anti-static mode: | Epoxy insulating board with heat dissipation holes on the surface |
| G | Truck structure form: | The test area is isolated from the load area |
| H | Aluminum alloy visual sliding door structure: | Product enclosed, viewable folding glass door |
| I | Car structure type: |
The fourth layer and the fifth layer of the product placement area are flipped structures, and the bottom working space is large to facilitate the loading and unloading of products
|
| 2 | Energy recovery module configuration, measured power and aging quantity introduction: | |
| A | Electronic load module control mode: | RS485 communication mode, host computer RS232 communication mode |
| B | Mounting load module model: | CP8102(1-500V,0.05-10A,100W/CH,) |
| C | Electronic load module isolation mode: |
Electronic load module channel adopts photoelectric isolation (communication and power supply isolation)
|
| D | Number of installed load modules: |
CP8102 load 10 units on each floor, a total of 6 layers, 60 units installed on the whole vehicle
|
| E | Energy-intensive load loading mode: | In CC mode, channels can be connected in parallel |
| F | Electronic load design architecture: |
No electrolytic capacitor, no relay, long life design scheme (independent intellectual property rights)
|
| G | Number of electronic load module channels: | 4CH |
| H | Single pass rated power of load module: |
100W/CH The power of the measured single-channel power supply is less than 100W
|
| I | Number of vehicle aging products: | Products with output power below 100W can be aged 240 bits |
| J | Number of parallel dual-channel aging products: |
Product output power below 200W products can be aged 120 sets (only CC mode can be parallel)
|